liftstar powered pallet truck custody the operation of the electrolyte

     1. Storage place: You can not make a short circuit; cause a short circuit may occur due to rain fire and may produce a small amount of hydrogen, the battery must be palle jacks‍ stored in a ventilated, cool place.

     2, scrap batteries: waste battery power is still there, should be kept in accordance with the methods used to store batteries.

        1. Check the specific gravity: Use a hydrometer to check the proportion of inhalation, do not let the electrolyte spill out of the job, and to wear protective gear.

     2, in addition to checking the operation of: professional advice should be, especially the electrolyte (sulfuric acid) when supplemented.

     3, electrolyte leakage: As the battery tipping, palle stackers‍ breakage resulting in electrolyte leakage, should be urgently addressed immediately (see emergency matters).

power pallet jack Provisions relating to electric pallet truck for safe operation

1, a vehicle safety device must complete and intact, the components sensitive and effective, good technical performance, non-vehicle travel sick.

2, to maintain the standard traveling state, Quick lift Hand Pallet Truck‍ fork forks from 10-20 cm from the ground when the ground running, fell to the ground with about poor road conditions in the work stops, it is important to reduce the appropriate and should reduce speed.

3, truck driving, such as electric controller out of control, then promptly disconnect the main power supply.

4. The use of electric vehicles in particular should pay attention to the timely and proper maintenance of battery charging batteries. Note that when the battery charging methods, both to make the battery is fully charged, the battery can not cause excessive charging.

5, in the electric vehicle operations, minimize the use of long-range acceleration time, when the vehicle is started, the speed increase after stabilize the accelerator pedal, such as better roads, the vehicle will continue to accelerate. Decelerate the vehicle need to relax the accelerator pedal, gently depress the brake pedal, which can take full advantage of the deceleration of energy, if the vehicle has a regenerative braking function, you can Rider Pallet Truck‍ make the kinetic energy is recovered during deceleration. When the vehicle ramp down, do not disconnect the drive motor circuit, gently depress the brake pedal, the vehicle runs on regenerative braking, the vehicle down the kinetic energy use and reduce the battery energy consumption.

6, the vehicle is running, do not "forward, backward" direction switch mistaken turn switch. Unless urgent need to slow down, do not directly to the brake pedal in the end. Vehicles using the process, found the battery is low (by electricity meter, power loss alarm indicator and other devices to get), you should charge the battery as soon as possible, to prevent excessive battery discharge.

7, the vehicle is running, not at high speed process, often taking emergency braking; otherwise the brake assembly, causing great friction wheels and shorten the brake assembly, the wheels liftstar ride on pallet trucks‍ of life, or even damage the brake assembly driving wheel.

Forklift spill has been plagued customers use the most common problem

Forklift spill has been plagued customers use the most common problem, whether it is internal combustion forklifts, electric cars and electric forklift trucks, or hand truck, shop crane‍ manual Stacker there leakage problem, the problem seems to be an oil spill unable to solve the problem for a long time, has been plagued by businesses and customers, but today we have to analyze those places easily spill, how will the oil spill, how to deal with.

First, the internal leakage:

Common causes forklift lifting cylinders can not afford or lifting forks and mast itself fell forward on their own fault. The reason endoleak and exclusion method:

(1) the gap between the stem and the body wear too much

Because long-term use or distribution palle jacks‍ valve dirty oil accelerated the stem and the body, such as wear and tear, damage the mating sealing surface, resulting in oil spills. If the valve stem when repairing wear light, polished chrome stem can; if the stem badly worn, replace.

liftstar powered pallet truck Forklift battery forklift battery is the power lies, and features three categories forklift battery:

     A dry-charged batteries

     Stands for dry charged lead-acid battery, its main feature is the negative plate has a higher electrical storage capacity, in a completely dry state powered pallet truck‍, the Rider Pallet Truck‍ resulting electricity can be saved in two years, when in use, simply add the electrolyte, so after 20-30 minutes can be used.

     2, maintenance-free batteries

     a, maintenance-free batteries due to their structural advantages, electrolyte consumption is very small, in the life of the basic need to add distilled water.

     b, also has shock, temperature, small size, low self-discharge characteristics.

     c, the battery life is generally twice as liftstar ride on pallet trucks‍ common.

     d, maintenance-free batteries on the market powered pallet truck‍, there are two: the first increase in the purchase of a one-time use, no maintenance after the electrolyte (add supplementary liquid); the other is the battery itself, the factory has been added to the electrolyte and good sealed, the user simply can not add supplementary liquid.

     3, ordinary batteries

     Ordinary battery plates are made of lead and lead oxide, the electrolyte is an aqueous solution of sulfuric acid. Its main advantage is that the voltage stability, cheap; drawback is the low palle stackers‍ specific energy (ie energy per kilogram of battery storage), life is short and frequent routine maintenance.

power pallet jack Jack, English (Jack) is a lifting height

Jack, English (Jack) is a lifting height is small (less than 1m) of the Quick lift Hand Pallet Truck‍ simplest lifting equipment. It has a mechanical hydraulic two. Jack is mainly used in factories, mines, transportation and other departments as vehicle repair and other lifting, support and so on. Its lightweight and sturdy structure, flexible and reliable, one person can carry and operate. A jack as a broad range of tools, using the highest quality hydraulic hand truck‍ materials cast, to ensure the quality and life of Jack.

electric pallet truck Jack

Jack is divided into two kinds of mechanical jacks and hydraulic jacks, each with a different principle. In principle, is based on the principle of hydraulic jacks for Pascal principle, Electric Hand Pallet Jacks‍ namely: the fluid pressure is the same everywhere, so that in a balanced system, the pressure is applied above the piston is relatively small is relatively small, and the large piston the applied pressure is relatively large, so that the liquid can be held stationary. So by passing the liquid, you can get different pressures on different ends, so that you can achieve the purpose of a transformation. Our hydraulic jack is common to use this principle to achieve transfer power. Mechanical jacks mechanical principle, reciprocating lever handle, pull push the ratchet claw rotary gap, small bevel gear drive big bevel gear, so weightlifting Quick lift Hand Pallet Truck‍ screw rotation, so that the hoisting or lifting the sleeve to get down to achieve the lifting tension function. But not as a simple hydraulic jack.

liftstar powered pallet truck The basic equation

The basic equation of static pressure (p = p0 + ρgh), placing a liquid in a sealed container, the pressure p0 is applied when it is changed, if the liquid remains unchanged to its electric stacker‍ original rest state, the liquid pressure at any point will occur both the same change in size. That is to say, in a sealed container, the liquid is applied to the static pressure at the same time will spread the points equivalent. This is known as Pascal static transfer principle or principles. Pascal's law of fluid mechanics, because the liquid flow, the pressure changes in a closed portion of the container occurs in the static fluid, the transmission of the same size in all directions. Pascal first expounded this law. Pressure exerted pressure equal liftstar hydraulic hand truck‍ to the force divided by area. According to Pascal's law, put some pressure on the hydraulic system of a piston, will produce the same incremental pressure on the other pistons. If the second area of ​​the first piston area of ​​the piston 10 times, the second force acting on the piston is increased as the first piston 10 times the pressure on the two pistons remain equal. This law is a French mathematician, physicist and philosopher Blaise Pascal first proposed. This law has a very important application, the hydraulic machine is an example of Pascal's principle in the production technology. It has a variety of uses, such as a hydraulic braking. Pascal also found that the static fluid pressure at any point in each direction are equal, i.e., the point through which the pressure on all the planes are equal. This fact is also known palle jacks‍ as Pascal's principle. 

Can be formulated as: P1 = P2 that F1 ÷ S1 = F2 ÷ S2‍

power pallet jack Lift is a vertical transport persons or lifting machinery

Lift is a vertical transport persons or lifting machinery. Also refers to the vertical transportation equipment in factories, warehouses and other hydraulic hand truck‍ logistics automated systems, often lifting platform is also equipped with a variety of flat conveying equipment, as connected devices at different heights conveying line. Generally use hydraulic drive, it said snorkels. In addition to cargo transport as a different height, but is widely used in high-altitude installation, maintenance and other operations. Lifts free lift characteristics has been widely used in municipal maintenance, terminals and logistics centers cargo transportation, construction and decoration, installation of car chassis, chassis and other car battery can walk in, working height space has also changed, with a light weight, self-propelled , electric start, electric stacker‍ since the legs, simple operation, a large work surface, can overcome obstacles to freely rotate 360 degrees advantage of high-altitude operations.