Wuxi forklift truck manufacturers tell you the important components: pressure transmitter

forklift jacks important components: pressure transmitterForklift In normal use, the pressure transmitter AC voltage with gear speed increases, so at work not only to confirm the electromagnetic induction coil good, you also should be detected with a multimeter AC voltage signal. Because electromagnetic angular velocity pressure transmitter with gear tooth spacing between the top of the speed measurement has a crucial impact.
 Pressure transmission output signal peak voltage amplitude and his gap related to the output value of the small air gap is large, this is more conducive to testing. But also for the manufacture of precision DUT progress with assembly requirements, which makes a corresponding increase in manufacturing costs; gap big pressure transmitter under test and assembly manufacturing precision parts that require low, but the output signal peak voltage amplitude is small, is not conducive to detect the first to use screw wrench pressure transmitter, pressure transmitter until the top section and the gear tooth contact; followed by a pressure transducer roundabout half circle, so the gap is 0.5 ~ 1.5mm ; finally tighten the lock nut, the pressure transmitter fixed.
 Install pressure pressure transmitter, pressure transmitter end should be positive for the gears. Fixed, you also need to measure the angular velocity of the pressure transmitter electromagnetic induction coil resistance size. Failure to observe AC voltage signal, check the pressure transmitter installation status; if observed AC voltage signal, you need to check the pressure transmitter is connected to the corresponding controller line.
 It can be seen, forklifts angular accuracy pressure transmitter installed or not on a great influence on measurement results, the air gap needs to be adjusted to an appropriate value, then multimeter to test whether intact, in order to put into use. Electromagnetic pressure transmitter pressure transmitter angular gap is also an important parameter, usually 0.5mm to 1.5mm as well. Therefore, the use of a forklift pressure transmitter is very much.